The SkynCap™ is built to last, but like any good beauty essential, it needs proper care to keep performing at its best. If you’ve used wig tape to secure your SkynCap, removing it correctly is key to maintaining the cap’s shape and durability—especially the delicate poly faux-skin material.

Follow these simple steps to gently remove wig tape from your SkynCap™ without causing any damage.

1. Gently Lift the Cap from Your Head

Start by slowly and carefully lifting the SkynCap™ from your head. Avoid tugging or pulling too hard, especially around the areas where the tape is applied. Use cleansing oil wig adhesive remover to help.

2. Prepare a Water Bath

Fill a sink or basin with room-temperature water. Avoid hot water, which can warp or weaken the material.

3. Soak the Cap

Place your SkynCap™ into the water, ensuring it’s fully submerged. Allow it to soak for at least 1 hour, or for best results, leave it overnight. This loosens the adhesive and softens any residue.

4. Peel Off the Wig Tape

After soaking, gently peel the wig tape away from the faux-skin area. Take your time—avoid scraping or stretching the material. If any adhesive remains, give it a bit more soak time.

5. Remove Excess Water

Once the tape is off, squeeze (don’t twist!) the cap gently to release any extra water.

6. Air Dry

Place the SkynCap™ on a stand or mannequin head to air dry completely. This helps retain its shape and keeps it ready for your next wear.

✨ Pro Tip:

For stubborn adhesive, a tiny bit of gentle oil-based remover (e.g. baby oil) can help. Always patch test and rinse thoroughly.

💖 Taking time to care for your SkynCap™ will extend its lifespan—and keep your wig prep clean and flawless every time.